Transmission cooler fitting8/23/2023 ![]() Step 6: Reattach your transmission fluid reservoir back onto its mounting position after installing all new hoses and clamps correctly around both sides of your radiator core support area Step 5: Use an appropriate type of hose clamp for sealing both ends of each line onto its corresponding port on the radiator, making sure that it is tight enough without over-tightening it (which can lead to cracks) Step 4: Connect one end of each line to their respective ports on the radiator and then fasten them in place with a wrench or screwdriver if necessary Make sure they are tightened down securely, but be gentle and don’t overtighten them either as this could cause leaks in the future.Step 3: Install new transmission cooler lines into place, being careful not to cross thread them as you do so Step 2: Locate and remove the existing lines connected to the radiator, making sure that all of the fluid is drained out before doing so Doing this will prevent any electrical shocks or potential damage to your vehicle from occurring while you’re working on it.Step 1: Start by disconnecting the negative battery terminal.After this has been done, reconnect all hoses that were removed during disassembly earlier as well as any clamps which may have also been taken off beforehand before you move onto attaching new ones if necessary. Place the other free end into its intended spot located at the backside of your radiator and hold it firmly in place before you begin tightening it down with a wench or adjustable wench as required for proper installation. Now fit one end of your new transmission cooler line onto where it was previously attached on the transmission side and tighten with a wrench or an adjustable wrench as needed to secure it in place.Ĥ. Once this is done, use a pair of pliers or an adjustable wrench to remove any clamps that may be present on either end of the old lines if necessary.ģ. Use a wrench to loosen them, then pull the lines away from each other until they are fully disconnected.Ģ. Begin by disconnecting both the transmission cooler line and radiator fitting from their respective sides of the engine bay.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |